Introduction: Long Parts on a Short Lathe

Picture of Long Parts on a Short Lathe

In September 2013 I had to process a very long piece on the lathe. The piece was 3.5m in length and 16mm in diameter. So I made two supports.

Step 1: Support

Picture of Support

Materials : 2200 Self Aligning Ball Bearing , 5 screws and 3 pieces of aluminum.

Step 2: Using

Picture of Using

I managed to go smoothly at 500 rpm.

Step 3:

Comments

About This Instructable

1,025views

23favorites

License:

Bio: I enjoy building things.
More by Stefan Gales:GEorgia, the Fusion MaidSimple Workshop Activity Monitoring SystemSimple Cooling System
Add instructable to: