Print PDF
Favorite
Email
Step 7Mount the Sensor and Display onto a Water Pipe
Use mastic or clay to attach the piezo to the tap, and another layer of mastic to secure the display on top.
You may have to readjust your threshold amplitude or 'MIDPOINT' from step 4. The signal may also be slightly affected by the temperature of the pipe.
You may have to readjust your threshold amplitude or 'MIDPOINT' from step 4. The signal may also be slightly affected by the temperature of the pipe.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
1
Dec 18, 2008. 9:45 AMbalam
says:
very nice I am wondering about the liking in of water and shorting the circuit that could fry the arduino board. how do you make this water proof
Reply
Dec 19, 2008. 6:08 PMthatmantheuser
says:
silicon
Reply
 |
Add Comment
|
