With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
I used old cedar fence slats to make stands for some new plants. This is a good material because it's highly resistant to moisture, and it was free. ...
Starting with a square makes marking easier. I glued up a large rectangle and cut my squares from it, but you could also glue up two, or however ...
First Find the center. Since my squares are about 13" x 13" - I measured 6.5" from two adjacent edges. I used a trammel/compass from The Home Depot ...
I marked the position of one leg by measuring about 3.5" from two adjacent edges. I used that mark to set up the fence with a stop block ...
Since this particular material is very soft, I didn't worry about cutting too close to the line. With a harder material, I'd try to get as close as ...
If more than one stand is desired, use the first as a template for the others. Trace the template and cut again.
Using double stick tape, stick the rough piece to the template. A pattern or flush trim bit makes quick work of the clean-up.
I used a bench hook to cut the legs to length. I slide the dowel to the edge of the bench hook and place the saw against the ...
I chose to chamfer the bottom edge, and ease the top edge with a small round-over (1/8"). The chamfer on the bottom makes the piece look thinner and ...
Pretty simple. No need to be careful, you can't see the bottom and gravity forces the legs to stay in place.
I used boiled linseed oil and paste wax for the finish. Flood the surface with oil and allow to sit for about ten minutes before thoroughly wiping off. ...
Wax finishes wear over time and should be reapplied as needed. I have a number of waxed pieces that have held up with no maintenance for a few ...
Standing Desk Conversion Platformby 5dots
DIY Standing Desk (in prep for treadmill desk)by nelagnelag
Nomad Furniture: design, case studies, and philosophyby Wade Tarzia
Simple Wood Dowel Plant Standby kkingsbury
Studio Monitor Speaker Standsby ddjack59
Join 2 million + to receive instant inspiration in your inbox.
Download our apps!
© 2015 Autodesk, Inc.
Enter the email associated with your account and we will send you your username and a temporary password.
Not a member? Sign Up »
Already a member? Login »
That's a pro feature!
Want to go pro?
First step is to sign up.
By clicking "Sign me up!" you are indicating that you have read and agree to the Terms of service.
Already a member?" Login »