Introduction: MAKE MINI USB LIGHT

MATERIALS REQUIRED

1)MALE USB CONNECTOR

2)LED

3)1OHM RESISTOR

Step 1: INSERT LED

INSERT POISTIVE END OF LED IN POSITIVE WIRE.

Step 2: INSERT RESISTOR

INSERT RESISTOR IN NEGATIVE END.

Step 3:

Step 4: POWER UP.

LAST TWO ENDS OF USB OUTLET ARE POWER OUTLETS WHEREAS MIDDLE TWO ARE DATA PINS,SO CONNECT LED AND RESISTOR TO LAST TWO ENDS.IF YOU ARE USING WIRED CONNECTOR THEN USE BLACK AND RED WIRE TO MAKE CONNECTIONS AS THEY CARRY POWER.

Comments

About This Instructable

374views

8favorites

License:

More by kaustubhc1:MAKE a PROPELLER FROM ICECREAM STICKMAKE MINI USB LIGHTUSE THIS INSTEAD OF DICE TO ENJOY BOARD GAMES EASILY!!
Add instructable to: