MAKE A SPACE PROBE

Step 3: Construction of the DAQ, probe tracking (GPS)

Preparation of the DAQ and GPS tracker.

• disassembly of this DAQ, removal of its casing and screen
• shortening of wires
• connecting the sensors to DAQ

We used the LabQuest DAQ, which we took apart and reduced its mass to almost one half. The board was then installed into the probe. We did the same thing with the GPS tracking unit. Both devices will later be installed in special compartments inside the probe. Three sensors will be mounted on the GPS unit, and will transmit live data during the flight.

The GPS unit we use is the BLACKBLOX GPS unit, can be bought HERE.