Print PDF
Favorite
Email
Step 9Cabling
Ah, time for drudgery. You'll need wires connecting your MCU to the potentiometer (see step 7 for a repeat of those details), connecting your MCU to the H-Bridge, and connecting the H-Bridge to the gearmotor.
You can keep your wiring minimal: just measure, cut, strip, and solder these wires.
For a more modular wiring system, use header pins and connectors and crimp-on wire terminations and heat-shrink tubing and rubber bands and zip ties and velcro straps and staples and ribbon cables and lots of expensive little parts from mouser.com. Seriously, making really good cables is a lot of work. Do whatever works best for your system.
You can keep your wiring minimal: just measure, cut, strip, and solder these wires.
For a more modular wiring system, use header pins and connectors and crimp-on wire terminations and heat-shrink tubing and rubber bands and zip ties and velcro straps and staples and ribbon cables and lots of expensive little parts from mouser.com. Seriously, making really good cables is a lot of work. Do whatever works best for your system.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
