Be a MIB agent for Halloween! It's a simple costume to do but to really make some impact you'll want to pull out the "big guns."
Step 1: Materials
First you'll need the obvious black jacket (preferably three button- I used a two button black blazer and added the third button), black pants, black shoes, black tie and white shirt. Don't forget the dark glasses!
Now for the fun stuff- for the blasters you'll need some MDF wood, sheet plastic or Sintra (PVC sheet sold by plastic suppliers and sign shops- cost about $35 for a 4x8 ft. sheet 1/8" thick), some wood screws, Bondo, epoxy, PVC cement and a few lengths of PVC pipe.
Step 2: Pulsar Blaster
My blaster of choice! The blaster body is made from two lengths of PVC pipe that are glued and screwed together. Then glue a piece of Sintra (use PVC cement) to create the flat section between the two PVC pipes (this is the Bondo covered section in the photo.)The bottom section is notched out and some Sintra sheet is then glued in and then a piece of MDF is epoxied and screwed to the flat Sintra sheet. This notched out section is what holds the slide on the bottom of the blaster.
The slide handle is made from a cut section of PVC pipe with ribs glued on. It has a piece of MDF glued inside it to hold the bearings for the slide. The slide itself is a surplus computer rack part I found at an electronics surplus store- a drawer slide might work as well (or just screw on the handle to the bottom of the blaster if you don't want it to move.)