MIB Halloween costume

Step 8 Tri Barrel Blaster- finishing up

Now add some details to the other side of the blaster body. This is made from a dowel with grooves cut into it, a knob epoxied on and a small piece of plastic sheet with holes drilled into it. Addtional dowels are cut at an angle and glued onto the back of the blaster body and have allen screws set into them.
The front of the barrels is finished by cutting a piece of Sintra sheet and gluing it onto the front of the barrels.

Now give both blasters a coat of primer and then a coat of silver paint!

Comments

[Honus]

I forgot to mention that all of the wood parts should be coated with a wood sealer before painitng.