loading
Picture of Magnetic Helper/Picker Upper- Quick and Easy
Image09042011230614.jpg
Image09042011234915.jpg
Image09042011234750.jpg
Image09042011230636.jpg

 
Remove these adsRemove these ads by Signing Up

Step 1: Materials

Picture of Materials
Image09042011230021.jpg
Image09042011224535.jpg
Image09042011224456.jpg
IMG_1342.JPG
Materials:
shaving razor handle
bottle cork
3 small neodymium magnets ( or 1 bigger one)
super glue
Xacto knife (I used my homemade toothbrush Xacto Knife)


Step 2: Fitting the cork

Picture of Fitting the cork
Image09042011224716.jpg
Image09042011224956.jpg
Image09042011224943.jpg
Image09042011225030.jpg
Image09042011225021.jpg
 Using an xacto knife, cut off a chunk of the cork, and then trim it to fit in the empty space on the razor handle,

Step 3: Fitting the magnets

Picture of Fitting the magnets
Image09042011225704.jpg
Image09042011225249.jpg
again using an xacto knife cut out a niche for the magnets to sit in so they are snug in the cork.

Step 4: Glueing it all together

Picture of Glueing it all together
Image09042011230246.jpg
Image09042011225428.jpg
Image09042011230412.jpg
Image09042011230614.jpg
Image09042011230636.jpg
check to make sure everything fits properly. once you are satisfied use super glue to secure everything in place. first the cork into the handle. then the magnets into the cork. at first i tried to glue all 3 magnets in at once but they just bunched together so i glued each one seperately. wait for all the glue to dry to try it out.

Step 5: FINISHED!

Now that you are done, you have yourself a nifty doing all sorts of magnetic things.

Enjoy, be safe, and feel free to leave comments, questions, improvements