Introduction: Make Lucid Dream Mask Under 1$ Using Attiny13

The lucid dream mask use some led wich blinks ,that help you to control your dreams

Step 1: Attiny13 Pinout

In this photo you can se pinout og attiny13 . attiny13 has 8 pin ,reset pin ,power,gnd and 5 pin we can use to program.

Step 2: Connect Attiny to Arduino

To programming attiny we will use arduino uno .

you have to install attiny library and open arduino go to tools ,programmer and select arduino as isp.
upload ArduinoISP . select attiny13 to tools board .

connect led in pin 1,2,3,4 of attiny chip.

Step 3:

Comments

About This Instructable

379views

15favorites

License:

More by Electronice:Make Lucid Dream Mask Under 1$ Using Attiny13How to Make Lucid DreamArduino Control Servo Motor Using Ultrasonic Sensor
Add instructable to: