With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
I used an old college lanyard to make a new collar for my dog, Bruce. To start, you need the following items: * One lanyard (must have a plastic ...
First, use the measuring tape to measure the length around your dog’s neck (you can also take an existing collar and measure the length of the fabric ...
Next, cut the lanyard apart, measure 11 inches of the cord, and cut. (Note: if there is a pattern to the cord, be mindful of where you cut.)
After cutting, take your lighter and slightly burn the edges of the cord. This will make it easier to feed the cord through the buckle, and will preve...
Then, slide the key ring and both ends of the plastic buckle onto the cord. Adjust the buckles so that there is 3 inches allowance on the end where th...
Pin down the loose edge one the side without the key and sew. I went back and forth a few times with the needle to ensure the strength of the seam.
Pin down the second edge, and sew a seam first directly next to the buckle. Then pull the key ring as close as you can to the new seam, pin down the r...
Clip all loose threads, and VOILA! A new collar for gameday! GO DUKES!
Remove these ads by
Signing Up
Not NiceInappropriateSpam3,023 views
5 favorites
Posted:
Oct 20, 2009
License:
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »