This is a go kart that I made and hopefully you will be able to as well. I used the back end of a bike and the front axle from a ride on lawnmower. Plus some other pieces of scrap I had lying around.
Before you begin there are some important thing you will need to have:
-Angle grinder (or if you don't have one a hacksaw)
-MIG Welder (this is the most important thing you will need)
-Basic tools (spanners, hammer, sockets, socket drive etc)
-And a lot of space to build the thing!
And remember if you have any questions please dont hesitate to ask.
Before you begin there are some important thing you will need to have:
-Angle grinder (or if you don't have one a hacksaw)
-MIG Welder (this is the most important thing you will need)
-Basic tools (spanners, hammer, sockets, socket drive etc)
-And a lot of space to build the thing!
And remember if you have any questions please dont hesitate to ask.
Remove these ads by
Signing UpStep 1: Finding a bike
This part is really the most important thing you are going to have to do in this whole build. Selecting a bike that is suitable for your specifications and requirements is cruicial.
There's really not a lot I can tell you about this except I chose a 1998 Suzuki Katana AY 50 because it was the only one I could get for free (it wasn't running, but I fixed it). I would recomend a bike like this but really any bike will do, as long as it starts and goes.
There's really not a lot I can tell you about this except I chose a 1998 Suzuki Katana AY 50 because it was the only one I could get for free (it wasn't running, but I fixed it). I would recomend a bike like this but really any bike will do, as long as it starts and goes.
Visit Our Store »
Go Pro Today »
who cares about grammar any ways
My only concern would have to be that it is gonna be WAAAAAY too hard to pop a wheelie using that scooter rear-end. We need to find you an old Ninja or something. ;)
Don't listen to the age discriminators. . . they're just jealous that they're too old to not know any better. :D