Print PDF
Favorite
Email
Step 7Wire
With the washer in place at the top of the lamp, screw on the base (or "cap") of the light fixture socket.
Push the cord up through the base and out through the socket cap at the top and tie what is called an underwriter's knot.
There are two screws on either side of the socket. Loosen these screws slightly. Wrap the ribbed wire around the silver screw and the other wire around the brass screw. Tighten with a screwdriver.
Pull the extra wire back into the lamp and snap the socket down into the cap and you are done!
Push the cord up through the base and out through the socket cap at the top and tie what is called an underwriter's knot.
There are two screws on either side of the socket. Loosen these screws slightly. Wrap the ribbed wire around the silver screw and the other wire around the brass screw. Tighten with a screwdriver.
Pull the extra wire back into the lamp and snap the socket down into the cap and you are done!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
