With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Need more light? Have extra glass bottles laying around? Want to recycle? This Instructable will show you how to make your very own glass bottle la...
Materials and Tools Recommended Personal Protective Equipment (PPE) Safety Glasses Fire Extinguisher Particulate...
Gather all the required materials before you begin this project. NOTE: You may want to perform the following steps in a well ventilated or outdoor ar...
Take the glass bottle you wish to cut and wash it out COMPLETELY. It is recommended that you remove the entire label. Fill the container or bucket a...
Cut a length of string that is long enough to wrap around the bottle at least 3 times. After the length of the string is cut, wrap it around the bott...
Carefully slide the loop of string off the bottle, being careful not to untie the ends. Soak the string in rubbing alcohol for 5 to 10 seconds. N...
CAUTION: Rubbing alcohol is flammable and will ignite on your hands. Be sure to thoroughly wash your hands before completing this step. CAUTION: REMO...
You should hear an audible pop that sounds similar to breaking glass. Once this is heard, carefully remove the two separated sections of the bottle fr...
In order to successfully complete this light assembly, it is required to have basic soldering skills. If you would like to learn how to solder there a...
Remove the bulb from the night light assembly so it is not broken in the disassembly process. Using the appropriate screwdriver, remove the screw fro...
Using a hammer and knife (or similar sharp edge), pry nightlight into two pieces along the seam. NOTE: It may take a considerable amount of forc...
Remove toggle switch and spring from the night light.
Remove electrical prongs by lightly tapping with a hammer. NOTE: It may be helpful to use a vise or by bracing the light housing on the edge of a...
Using wire cutters, remove socket side of of extension cord. NOTE: Do not cut the pronged side of the cord. Pull apart the insulation holding t...
Remove the metal contacts from inside the nightlight housing. Carve 2 holes 1/4" apart from each other in the bottom of the nightlight using the knif...
Install contacts back into the night light and reassemble the two halves with the screw saved earlier.
Test the light by plugging it into a socket. Have fun trying your own ideas.
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »