Print PDF
Favorite
Email
Step 6Third jack
To wire the third jack, drop the third jack in the panel then wire it up just like the 1st and 2nd.
Trim any excess wire.
Trim any excess wire.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Mar 22, 2009. 10:54 PMinsturctables
says:
Dude, that thing's going to be an EMI magnet . . . not to mention all the NEXT potential. Wouldn't it be better to try to maintain the twists to within 1/2" or better of the IDC blades? If it were me, I would put a hairpin bend in each wire at the tap jack and push the entire bend (both sides of the wire) into the IDC. That would allow both conductors of each set (solid and stripe) to be near one another to allow for twisting. Otherwise a great instructable.
Reply
 |
Add Comment
|
