Step 4: Solder

Double check to make sure the shell body is the same measurement of the original pen tube. In this case it’s just under 119mm. Set the shells up and apply soldering paste as needed. Cut a couple small strips of solder and place them on either side of the joint. A little heat from a torch and you’ll have a solid pen body.
<p>What a great instructable. When I make one I am going to try to somehow use a spent .22 cal. shell as the button.</p>
What if I don't have a lethe but I want to do this, any tips? Plus this is a great instructable!
<p>GREAT INSTRUCTABLE ! ! This is my first pen. It didn't come out perfectly but thats why I'm keeping it. It writes and balances great in the hand. I don't have a metal lathe or a doming block so I had to mod the process a bit but it came out great. I need to polish a bit more in the future and perfect my soldering but other than that I'm stoked with how it came out. I need to make 15 more for Christmas presents for all they guys in the family. Thanks for putting this up. AWESOME!</p>
Fantastic! Thanks for sharing. They'll love it.
<p>I have been looking for something to do with all my 30-06 brass since I don't reload and I don't shoot enough to sell it or reload it. Hoping someday I'll reload but for now I think this is the best idea I've seen. Plus they'll make a few great christmas presents!</p>
This is extremely awsome!!! ive seen many like it but this method has to be the best in my opinion! Thanks!
can you make one of these pens with a .22 calibre bullet shell?
The diameter of a 22 shell is too small for the pen parts. You could make a stick pen though.
You, sir, are the reason I invested in a HF 7X10 metal lathe! I LOVE this idea (I've always collected pens) and have made a few for myself (I can't seem to keep one when co-workers keep asking for one or 'accidentally' pilfering them). This pen had a very nice weight and feel to it. Definitely a great ice breaker and conversation starter!<br>I looked for awhile and think I found the donor pen you used. Was it the Papermate Ink Joy?<br><br>Thank you for sharing this and for reigniting the desire to pursue a hobby in metal machining.
Great! Looking forward to see what you come up with. You've got the right pen.
This is a REAL ballistic pen. = ) Great job!
PS: You've got my vote.
Thanks! Fingers crossed.
Great project, thanks for sharing your technique. I can't wait to try it.<br>I have a few questions...<br><br>I don't have a doming block. Is there any reason why filing a taper on the end of the casing wouldn't work?<br><br>Did you consider using an actual bullet for the tip?<br><br>Do you find the brass keeps its sheen over time?<br><br>
You can file a taper and that should work fine. You could also use a spoon to roll the edge over by tapping it like a hammer. Over time the pen will oxidize like brass does but it's eaisily cleaned right up.
Extremely well planned, executed, and documented, you do fine work sir! You make me want to move 'lathe' up a couple of priorities on my workshop shopping list
I love this! I had to do a double-take when I first saw it.<br /><br />(Also, the shopping list is hilarious)
Glad you like it. Took a long time to figure out.
Awesome job!
That is very cool!

About This Instructable


178 favorites

Bio: Fish Bone. Paracord's new best friend.
More by Mrballeng: Cord Keeping CRAB Laundry Room Cabinets. DIY. Acrobat Cable Cam
Add instructable to: