Print PDF
Favorite
Email
Step 8Make it: SD Card, Speaker, Display
Connect the speaker to the Propeller, then the SD Card. Note that each line on the SD card has a pull-up 10k resistor.
Connect the LCD Display. This is a complicated connection - refer to the schematic for each pin. Note that DB4-DB7 go through 4.7k resistors.
Finally add the switches you'll use for input.
Connect the LCD Display. This is a complicated connection - refer to the schematic for each pin. Note that DB4-DB7 go through 4.7k resistors.
Finally add the switches you'll use for input.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
