Print PDF
Favorite
Email
Step 6Put Felt on the Dremel Guard (optional step)
The Dremel guard was making small scratches in the acrylic, so I put a ring of felt on the surface. This is an optional step that you might want to ignore if you're not scratching the plastic.
If you want to eliminate two overlapping holograms, cut half of the felt as shown in the last photo. This will tilt the tool slightly, so you will scratch arcs rather than complete circles.
If you want to eliminate two overlapping holograms, cut half of the felt as shown in the last photo. This will tilt the tool slightly, so you will scratch arcs rather than complete circles.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
