Remove these ads by
Signing UpStep 1: Glue together Wood
48"X1/2" Oak trim piece
24"X1/2" Poplar trim piece
bottle of gorrila glue
Stanley hand planer
bundle of jute rope (In the future, hemp would probably be better)
The hand planer from lowes turned out to be just the ticket for shaving down the bow arms to what I needed. Its only 6 bucks and its about 3"X1" big. Any bigger would probably turn out to be too unweildy. Any sort of wood glue would work really.. as a matter of fact, gorrila glue is probably not the best one to use. The wood was just some project wood or you could use trim wood too, I guess.
This is pretty self-explanatory, just make sure you get the glue more evenly spread than it is in this picture. Use sticks and rope as a clamp and the piece until its cured enough to release. This should actually take a few hours but since I'm really impatient, I waited for half an hour and then started carving. Dont do that, it just messes things up in further steps. Whatever you do, don't try bending the bow until the glue is dry either. This just makes them pop apart.










































Visit Our Store »
Go Pro Today »




How much is the pull weight? How heavy is the bow?
Thanks!
Any wood that is strong can be used. Flexible is also a feature to look for. Bows can be made of more than one wood also, with layers to make for a different behavior altogether.
Fiberglass is also a great material for making bows.
A jig is easy to set up with 2 nails and a plank of wood.
Set the nails partway in a plank of wood about as far apart as the string should be long.
Wrap 7-8 times around the nails with floss. Tie ends together so you have a big loop.
Now wrap floss tightly in a spiral over 4inch sections in the middle of both sides of the loop.
Slide the wrapped sections so they are around the nails.
Now wrap floss tightly both sides together about a 4 inch section in the middle for the arrow notch.
Pinch together the wrapped sections at each end to form a hole for the bow ends and wrap tightly with floss. Now you can take your finished string off the nail jig.