Step 6: Commoning all the wires.

Since each LED circuit is powered from a common supply, they are all connected in parallel. This is done as shown by cropping all the wires to the same length and stripping a generous amount of each wire. Typically about 3/4" (15mm). They are then twisted together and soldered.
add an arduino to flash the leds<br />

About This Instructable


13 favorites


Bio: Self employed industrial electrician who likes taking stuff to bits and modifying it, or building completely new stuff. There's nothing nicer than a completely ... More »
More by bigclive: Make a simple LED tester. Build a better RGB LED controller. Make a hackable LED ornament.
Add instructable to: