Introduction: Make a Programmable LED Jack-o-lantern for Halloween!

An LED pumpkin built with:
1. TI Launchpad MSP-430
2. 5 LED's
3. 5 100 ohm resistors
4. 1 pumpkin (I used artificial)
5. a little wire and solder
6. small breadboard
7. aluminum foil and tiny cups


About This Instructable




Bio: Electronics are a newly re-found hobby for me. I'm not an engineer - I'm an ordinary guy who likes to tinker with electronics in ... More »
More by meanpc:How to Negotiate at Garage SalesHow to Plan Your Garage Sale Route Using Google Earth (for EBay Sellers)Potentiometers and AnalogRead - How to Arduino #4
Add instructable to: