Print PDF
Favorite
Email
Step 2Fan
Nothing major here.
--pick a fan
I based my descision on mount location/size, noise, amp/volt.
Found a small 12v that was quiet, had lowest current draw from selection, offered sufficient
airflow, and fit a blank face plate.
--find a way to mate it to the internal molex
I had a fan molex connector, cut off unneccessary leads and soldered/shrink wrapped to new
fan. You could just as easily solder inline to orig. molex.
--pick a fan
I based my descision on mount location/size, noise, amp/volt.
Found a small 12v that was quiet, had lowest current draw from selection, offered sufficient
airflow, and fit a blank face plate.
--find a way to mate it to the internal molex
I had a fan molex connector, cut off unneccessary leads and soldered/shrink wrapped to new
fan. You could just as easily solder inline to orig. molex.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
