Introduction: Make an IPad Clutch Case

Picture of Make an IPad Clutch Case

Here's how to make a quick and easy yet stylish ipad clutch holder with nothing more than a scrap of fabric and some duct tape. You can use any fabric for this ipad clutch holder, but the thicker the better. We used a red faux suede to make this ipad clutch holder.

Step 1:

Picture of

You will need:

Piece of fabric slightly wider than your ipad and about 15cm longer, pair of scissors and some duct tape. We were going to use silver and black, but found that the black looked stunning on its own.

Step 2:

Picture of

1. With the fabric face down on a flat surface, fold over a section that is slightly wider than your ipad. Place half the width of the duct tape under one side, cut off the excess and then fold this over onto the top side. The duct tape has now closed the seam on this side.

Step 3:

Picture of

2. Repeat the above step for the other side.

Step 4:

Picture of

3. Do the same along the top edge. This will give it extra strength and also prevent the edges from fraying. If you are using a fabric that frays easily you may also need to place a strip of tape along the top pocket.

Step 5:

Picture of

This is what your ipad clutch holder should look like once finished. How easy was that!

Don't forget that you can find plenty more quick and easy projects on

See you soon!


dezine (author)2012-08-28

You could also stick velcro onto the flap as an easy closure. Janice -

Master97865 (author)2012-08-28

thats really cool and easy! im gonna make one too. i'd add a pretty button to close it though. thanks for posting

Penolopy Bulnick (author)2012-08-27

Awesome! Very easy :)

About This Instructable




Bio: Easy and affordable DIY projects and ideas.
More by dezine:Rope BasketCoffee Table With Storage CompartmentMake a Pine Bread Box
Add instructable to: