Step 3: Making a slot for the battery pack
Handle, Step 2: CUTTING HOLES/SLOTS IN THE HANDLE:
1) The Jedi must decide where he/she wishes to place the button/switch. Drill a hole there to fit the button/switch snugly.
2) Cut slot in bottom of handle for battery pack if desired:
TIPS:
FOR SMALL SLITS:
-use PVC cutter to cut where the end of the slit will be.
-then simply use PVC cutter to cut the slit itself.
FOR LARGE SLITS (longer than PVC cutter blade)
-use PVC cutter to cut where the end of the slit will be.
-use hack-saw to cut sides of slit itself in a long straight line.
1) The Jedi must decide where he/she wishes to place the button/switch. Drill a hole there to fit the button/switch snugly.
2) Cut slot in bottom of handle for battery pack if desired:
TIPS:
FOR SMALL SLITS:
-use PVC cutter to cut where the end of the slit will be.
-then simply use PVC cutter to cut the slit itself.
FOR LARGE SLITS (longer than PVC cutter blade)
-use PVC cutter to cut where the end of the slit will be.
-use hack-saw to cut sides of slit itself in a long straight line.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
14
weasel999
says:
Sep 12, 2009. 10:12 AMReply
its probably a better idea to use a soldering iron to melt through the PVC
Kayla Ree
in reply to Oct 22, 2010. 3:48 PMReply
but it would smell really bad!
2
red-king
in reply to Oct 3, 2009. 10:30 AMReply
toxic fumes....
spaztec
in reply to Feb 15, 2010. 9:53 PMReply
it's all good.
2
red-king
in reply to Feb 19, 2010. 1:42 PMReply
as my father used to say: "It's all fun and games, until someone loses an eye." or in this case" It's all fun and games until someone breathes in toxic fumes.
spaztec
in reply to Feb 19, 2010. 5:35 PMReply
yeah, its all goo.
fireruler12
says:
Aug 1, 2009. 8:49 AMReply
this is kinda confusing how much did it cost to make this
Visit Our Store »
Go Pro Today »
