Print PDF
Favorite
Email
Step 3Cut out a full set of rotors
Cut out one or more sets of rotors, and laminate them if you are using a laminator.
If you are laminating them, make sure you leave at least 10mm (2/5") between the rotors so that you can cut them out with a few millimeters (about 1/8") around them so that they stay nice and strong.
Also, if you are laminating, after you cut the rotors out I find it helpful to cut a little nick into the index position (the double fat black or white mark on the outside of each rotor), so that you can (a) find it; and (b) use a finger nail to easily rotate it.
If you are laminating them, make sure you leave at least 10mm (2/5") between the rotors so that you can cut them out with a few millimeters (about 1/8") around them so that they stay nice and strong.
Also, if you are laminating, after you cut the rotors out I find it helpful to cut a little nick into the index position (the double fat black or white mark on the outside of each rotor), so that you can (a) find it; and (b) use a finger nail to easily rotate it.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
