Maker Tin

Step 2 Super Glue

For this step I tried putting the glue in the small container but it went everywhere, got on my clothes and then dried up in the container.

So for this step you need a half (or nearly) empty tube of glue.

1 - Use a glue stick or other small cylinder to push the glue towards the nozzle end
2 - Cut the tube in half (don't cut right next to where the glue is or it will come out)
3 - Using tweezers and pliers pinch and roll the end of the tube up
4 - Put in tin !

Note -
This can get messy so DONT wear your favorite t-shirt
Be careful where you cut because there could be a glue explosion..

Comments

[h0meIandsecurity]

no, no, no!!! IT IS MUCH BETTER TO USE TUBE FROM HEATSINK TERMAL GREASE BECAUSE IT IS EASY TO USE AND IT IS LITTLE !!!

[Robot Lover]

yeah they are called single use ones so i suggest you put a new tube in every time you use it

[captainwiggles]

I was at a fabric store the other day and I found a pack of small super glue tubes that would work perfect for these type of tin kits. I think it was 4 tubes for a dollar. The tubes are about 1/4 size and are marked as "single use"

[=SMART=]

Awesome, ive never seen those, ill keep an eye out !!