Print PDF
Favorite
Email
Step 4Fit in battery holder
Use a single cell AA battery holder - it will just fit into case, and miss the shoulder buttons in place.
Notice there is space for a small switch to turn the system on and off, located above the battery holder in the picture.
The bit in the middle of the controller in the first picture should be removed so the clear plastic circle for the LED to shine through (from the BGP100 controller) can be inserted there. It is in the perfect position as when the board is in place (picture 2) the LED on the board is in just the right position.
Notice there is space for a small switch to turn the system on and off, located above the battery holder in the picture.
The bit in the middle of the controller in the first picture should be removed so the clear plastic circle for the LED to shine through (from the BGP100 controller) can be inserted there. It is in the perfect position as when the board is in place (picture 2) the LED on the board is in just the right position.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
