With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
If, like many, you like the BGP100 bluetooth gadget for playing bluetooth on smartphones and PDA's, but don't like the buttons and feel of the control...
Open up the SNES controller, remove the plug that connects the cable to the controller, and remove the cable too. Remove the parts of the casing high...
There is no space for an AA battery to fit inside without cutting some of the controller board down a bit. You want to make sure the traces are preser...
Here are the steps to open up the bluetooth BGP100 device. The board section with the D-pad can be removed as it is only a contact board that uses th...
Use a single cell AA battery holder - it will just fit into case, and miss the shoulder buttons in place. Notice there is space for a small switch to...
Wire up the controller after cutting traces as per pic - the idea is to be able to solder wires to the controller pad but that the wires don't get in ...
You need to make sure that the controller works fine, and the rubber contact pads make good contact with the board and also that the case halves of th...
Switch system on and there should be a green light flashing on and off to indicate it is talking to your system. You notice the on/off switch above t...
The same principle was used a while back when making a PSone controller into bluetooth too:
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »