I did this at TechShop Menlo Park. http://www.techshop.com

n trying to make a happier living environment on a houseboat I needed a cute sink cover. I made it out of wood.

Step 1: Image

I found this mushroom image online and inverted it, tweeked a little bit and made it to fit the size of the piece of wood I'm using

Step 2: Prepare for Laser Etching

This is the file in preparation for lasering onto the wood.

Step 3: Laser Etching

I loaded the wood and sent the file to the laser. This took about 3 hours to etch.

Step 4: Finisher Etching!

Mushrooms are ready to cover the sink and turn it into a fun place to look at. :)

About This Instructable




More by Miss Cabbit:How to clean out a rusty gas tank and replace oil on a moped Making a sink cover for a house boat Making a collapsible dog ramp for a houseboat 
Add instructable to: