Print PDF
Favorite
Email
Step 8Refining the band
Find the midpoint of your shaped ring using a ruler and the dividing scribes.
Mark the center point all the way around the band, and mark the cross center point of the flat top.
Using the center lines and your drawing as a reference, block out the areas for the stone seats and the width of the final ring shank.
Use the saw with a 3/0 blade to cut lines to define the areas for the stone seats.
Use a flat escapement needle file to cut down the stone seats to 0.5mm bigger than their final heights and widths.
Mark the center point all the way around the band, and mark the cross center point of the flat top.
Using the center lines and your drawing as a reference, block out the areas for the stone seats and the width of the final ring shank.
Use the saw with a 3/0 blade to cut lines to define the areas for the stone seats.
Use a flat escapement needle file to cut down the stone seats to 0.5mm bigger than their final heights and widths.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
