Introduction: Microphone Windscreen

Picture of Microphone Windscreen

so the situation is, I don't have a windscreen or a pop filter (also I'm too lazy to build one myself) but what I have are loads of sponges that was scrapped from old foams.

so here's my first Instructable, hope you guys enjoy it!

Step 1: What You'll Need

Picture of What You'll Need

A sponge or a foam

A cutter

A hot glue gun

Step 2: Slice It in Half!

Picture of Slice It in Half!

first thing you do is slice it in half, as shown in the photo

Step 3: Cut It Into 2!

Picture of Cut It Into 2!

so after you sliced your sponge into 2, measure the head of your microphone, then cut your foam to size.

Step 4: GLUING TIIIIIIIIIME!

Picture of GLUING  TIIIIIIIIIME!

so after you've cut your foam to size, you then glue the sides of your foam to one another, then you can use either a zip tie or a thread to secure it.

Comments

peppypickle (author)2014-11-26

very clever! and cost effective too!

About This Instructable

551views

13favorites

License:

Bio: started learning electronics back when I was 12.
More by jankeifer:Solder Fume Vent From An Old PSUResistor OrganizerAudio Projects Hum Problems
Add instructable to: