Mineral Oil Submerged PC

Step 5 Sealing the Deal

The final step. All we need to do now is to make it as air tight as possible. To seal off the lid, we took a hot glue gun and doused it with glue. We just placed it around the perimeter to the best of our abilities, (you can view the images below for a better idea).

Comments

[theuke]

good idea for an upgrade ssd inside no little airhole

[Nyxius]

I was going to suggest the same thing.

[some_guy89]

to get a better seal, you may want to put a bead of silicone around where it is joined. That is how glass aquariums are sealed.

[Mr. Anguish]

for an even better seal (if you don't ever want to remove the lid) use some form of "Plasti-Weld" or JB Weld... it will make a completely liquid and air tight joint.... i've used this stuff (the plasti-weld) to seal an old air mattress, and it worked fantastic, JB is just as good...

[general-Insano]

Is the hard drive going to be on the outside of the case?

[maxpower49]

yes it has to be it says on the bottem of the last step