Introduction: Mini Buckyball Gun (Does Not Shoot)

Step 1: Hexagons

Take 18 buckyballs and wrap them around into a hexagon. You are going to make 3 of these.

Step 2: More Hexagons

Take 19 buckyballs and wrap them around into a hexagon so that the middle hole is filled. You are going to make 3 of these as well.

Step 3: Making the Outline

Arrange your hexagons together like so with the open-middle hexagons in the center and the closed-middle hexagons on the edges.

Step 4: Adjusting

Take out the 3 buckyballs that were taken out from the picture. This will make the trigger. Do this for both sides.

Step 5: Adjusting Pt. 2

Take out part of the bottom layer like in the picture. This will make the handle more slim and not as bulky.

Step 6: Adjusting Pt. 3

Take 5 buckyballs and add them to the top of the outline. This will make the barrel longer and more like a gun. This is what the overall layout will look like.

Step 7: Almost Done

Fold the outline in half like in the picture.

Step 8: You Are Finished

There you go. You have made a buckyball gun.


DarrellL1 made it! (author)2014-11-19

Awesome gun! Although I was a bit confused by step 4. You might probably want to remove it.

Photo on 20-11-14 at 12.01.jpg
wammer2000 made it! (author)wammer20002014-11-20

Thanks! looks good.

Ya I just noticed that I kinda messed up the order of the steps I'll get on that right away.

About This Instructable




More by wammer2000:K'NEX Switch BladeMini Buckyball Gun (Does Not Shoot)
Add instructable to: