Print PDF
Favorite
Email
Step 2Assemble
1. Insert the wires in the two holes you made in the chamber ( marker ) and take a peek inside the chamber and make sure every time you press on the igniter you see a spark jump from wire to wire.
2. Take some precaution and shield yourself from the shock of the igniter by wrapping it with electrical tape or find a small rubber end cap by coincidence and place on contact pad over the wire. Doing so will give you better results upon ignition.
3. Insert barrel ( Bic pen ) into where the felt tip of the marker used to be and you should find that it fits snugly ( Glue if you wish, I decided not to so i can breech load it instead of ramming the projectile down the tube )
The Miniature Spud Gun Is Complete, Make Projectiles... Be Creative Damnit !
2. Take some precaution and shield yourself from the shock of the igniter by wrapping it with electrical tape or find a small rubber end cap by coincidence and place on contact pad over the wire. Doing so will give you better results upon ignition.
3. Insert barrel ( Bic pen ) into where the felt tip of the marker used to be and you should find that it fits snugly ( Glue if you wish, I decided not to so i can breech load it instead of ramming the projectile down the tube )
The Miniature Spud Gun Is Complete, Make Projectiles... Be Creative Damnit !
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
2
Aug 9, 2010. 2:16 AMelenwaren
says:
so many nice
Reply
 |
Add Comment
|
