Step 5: Making the front panel

Wait until your neighbors are doing construction, so that you can have their carpenter come cut out holes for your outlet face. (At least that's what I did).

It's much better to cut the face too small than too large. I had to tap mine in with a hammer, and that seemed to wok very will at keeping it in.

Then, I covered the holes with tape and used liquid nail to seal in the cracks. Once it dries, I'll sand it down, and maybe paint it black like the box.

This is perfect, finally found an instructable that I can do. This is perfect for my disco picnic!
THIS IS EXACLY WHAT I WAS LOOKING FOR!!!!!! whats the aproximat cost for this over all

About This Instructable


39 favorites


More by stanparker: Mobile Power Anywhere
Add instructable to: