Print PDF
Favorite
Email
Step 5Connect the wires & test
Solder the wires coming to the recording head to the wires of your plug.
Of course white to white. Red to red. Ground to ground.
Test the whole setup to see if it works, then insulate them well.
Of course white to white. Red to red. Ground to ground.
Test the whole setup to see if it works, then insulate them well.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Aug 16, 2011. 7:26 PMdandrade4
says:
a lot of newer headphones have cheap thinner wire which is hard to use so it'd be better to get new wire for this. if you can manage or have the right materials to remove the enamel from the cheapo thin wire - they aren't always white red and black. maybe red and blue/green and one copper on each side. so two coppers to the one un-shielded wire and red to red blue/green to white. I would say. that's what i've done when splicing audio devices together.
Reply
Oct 18, 2011. 12:05 PMTheDutchOwner
says:
If you have old PC speakers, its audio cable works too.
Reply
 |
Add Comment
|
