Introduction: Modded NERF Clip Airsoft Darts

Picture of Modded NERF Clip Airsoft Darts


This is how to make a modded clip dart. This flies farther and hurts MUCH more.


WARNING! THIS CAN ACTUALLY HURT. USE COMMON SENSE.

This was made in a collaboration with pandamoose.

This is my first Instructable.

Step 1: Supplies

Picture of Supplies

All you need to make these darts with is a knife, a clip system dart, and .12 gram airsoft bbs (or smaller but .12 work best)

Step 2: Construction

Picture of Construction


Take your knife and make a small incision leading from the hole at the tip of the dart. Don't make it too large of a cut otherwise pellet will not stay in. Be reasonable. Push pellet inside the tip of the dart. You're done!

Comments

Lightning1287 (author)2011-11-15

That's a nice knife. =D

b11484 (author)2011-09-05

Add tape.

About This Instructable

1,204views

0favorites

License:

Bio: Currently a freshman at MVHS. I like to make stuff, listen to music, read, and play video games.
More by pandabird13:
Add instructable to: