Print PDF
Favorite
Email
Step 1Bits needed
You shouldn't need more than the fairly standard soldering tools, a multimeter, and a couple of resistors (not shown) -- I grabbed a couple of SMT resistors from an old CDROM drive.
If you want the very simple steps without any instructions, all I did was connect a 27k Ohm resistor from V+ (Pin 1) to D- (Pin 2), then another 12k Ohm between D- and D+ (Pin 3). Dead easy.
If you want the very simple steps without any instructions, all I did was connect a 27k Ohm resistor from V+ (Pin 1) to D- (Pin 2), then another 12k Ohm between D- and D+ (Pin 3). Dead easy.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
