Step 1: Gathering Supplies

This is going to be a busy project. To complete it you will need: 1.  Paper                    -5 or 6 sheets of regular printer paper, (20lb -...

Step 2: Lets get Cutting and folding!

you are going to need to cut your paper into small rectangles that are twice as wide as they are tall. For the dragon in the picture I used 2 inch by ...

Step 3: Completed Module

Good Job, you have finished your first modular unit. take note of the two flaps and the pocket in the picture below. Now go make about 120 more of the...

Step 4: Assembling Modules.

Assemble the modules by inserting the tabs into the pockets, as we go this will make more sense, but trust me, it is very simple. You add new modules ...

Step 5: LETS MAKE A DRAGON!

Ok, so you have your modular units, and you have a mildy confused idea of how they go together. Good. The assembly will start making a whole lot more ...

Step 6: starting the body.

ok, lets change views and start on the hard part.

Step 7: continuing the body

Now we need to make a place to add the spikes while continuing the body construction.

Step 8: Hips and Tail

Now to start on the mounts for the rear legs and the tail.

Step 9: Here we are so far.

Your model should look something like this by now.

Step 10: lets make some legs

Now we are going to make the legs, you will need 26 units for this step.

Step 11: folding the feet and horns.

This step shows you how to modify units to make the feet and horns. you will need 5 units for this step. Remember to save one of the claw units for th...

Step 12: making the spike unit

these are more modified units, i call them the spike units. You will need to make seven of them for this dragon. 4 for the back, 2 for the head, and o...

Step 13: Making the horns and assembling the head.

Step 14: Finishing the tail.

It is time to add a spike to the tail. You will need a claw unit for this. 

Step 15: Adding the feet and attaching the legs and spikes

Now we are going to add the feet to the legs (see i dint forget) and then attach the whole thing to the body. Remember, the front legs were slightly l...

Step 16: here we are!

Your dragon is mostly done! you can paint it at this point or you can try to glue him together! To glue him beak him down into sections. i like to do ...