Introduction: Moldmaking With Clear Silicone Rubber

When a project requires a complex parting line, it is often easier to pour the entire mold in one process with clear rubber, then cut your parting line. This process also saves at least a day in creating the mold.

To see other mold making videos see


Tonyisme (author)2009-07-05

Slightly over explained but VERY COOOOOOL

Bazzatron (author)2009-05-12

I can totally do this at home! Now where did i leave my vac chamber and pressure pot....

Avasar10000 (author)2009-01-09

I enjoyed you INSTRUCTABLE very much. I had not seen the "bombs away method" before; that will be useful. Thank you for that tip. Is it possible to build a vacuum degassing unit? As you pointed out, they are not very economical if purchased outright. I will be molding small items. I thought of building one out of a standard 1 gal paint can and an expended food saver vacuum type product. I do not know much else regarding the necessary mechanics of the unit though. Any help, or link to a ‘how to would” be appreciated. Thank you – Avasar10000

rsr (author)2008-11-19

Awesome time saver, I have been using transparent silicone rubber from rubber sheet roll. I was press molding two sides of the part bu this makes way more sense.

GorillazMiko (author)2007-12-26

ok now this is great! (+)

astrozombies138 (author)2007-12-26

superb instructable +

About This Instructable



More by freemanmfg:Epoxy Laminating SystemsSurface CastingMoldmaking With Clear Silicone Rubber
Add instructable to: