With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Got yourself a classic 1992 Bally Doctor Who pinball? Did you know the first units coming off the assembly line had a moving Dalek robot? The bean counters ...
You will need the Ultimate Dr Who Wobble Head Kit by diypinball(r) available at from http://wobbleheadkit.com
Using an 1/8" drill bit, drill a hole in the Dalek's head
The head is glued to the body. Pry it off using only your hands. Do not pull the robot's nose. Apply pressure between the bottom lip of the ...
Center the motor's bracket in the neck of the body. Note there are four screws that protrude a bit from the bracket that will help you center the ...
There are four outside holes, mark them for drilling.
Drill the holes you just marked in the previous step
There are four large flat head screws that hold the motor assembly into the head. Ensure they are totally flat and remove any extra plastic squeeze-out that may ...
For shipping reasons, the control board isn't attached to the motor. Attach it now using two cap head screws and a 7/64” Hex Wrench.
The wobble head kit from http://wobbleheadkit.com comes with the servo already connected; however, should you accidentally disconnect it, you will want to reconnect it to the three pin ...
Install the bracket within the Dalek head. Use the two supplied small flat head screws. Make sure the bracket faces the nose of the robot as shown.
Before installing the head to the Dalek, you'll want to put the fender washer under the bracket and the large pan head screw through it. Hold it upside ...
Make sure that the square in the bracket is sitting on the rod correctly, then once the screw is started, you can flip the robot right side up ...
Zombie doctor whoby zo'gorman
Interactive Doctor Who Computer Quiz.by steve-gibbs5
The Fat Cat No Free Lunch Diet With Multiple Cats or 1 Cat As Well by MissTalon
G25 E-brake From Junkby fman111111
Movie Accurate Optimus Prime (With Blue LED's)by FTLtechguy
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.