Print PDF
Favorite
Email
Step 3Drill Seat Pin Holes
Drill holes in the end of the dowels. This is required to accept the pins on the canvas seat.
1. Drill a 3/16" hole 2" deep into the center of the dowels at the fittings on the Upper Section and Lower Section .
2. Drill a hole in only one end of the Middle Section.
1. Drill a 3/16" hole 2" deep into the center of the dowels at the fittings on the Upper Section and Lower Section .
2. Drill a hole in only one end of the Middle Section.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
