With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
share step-by-step photos with text instructions
share one or more photos in one step quickly and easily
share your how-to video
I'm not going to get too specific with measurements here, since my goal was to make a one size fits all dispenser. I just took all the rolls of tape ...
Once the bottom is cut to length it's time to prep that piece for the middle piece that will separate your smaller tapes from your larger tapes (small...
For this operation I cut the center piece to 8" in length and stuck it in the previously routed grove on the bottom piece. Once that was in place (bu...
In this step you are going to be marking the sides and middle for the slots that will ultimately hold the PVC your tape is on. Start with your two si...
Use a router to bust out 4 "U" shaped slots where you marked them in the previous step. For the end pieces you can set your router to approximately 1...
Cut a new piece the same length as the bottom piece. Once this is done rip this new piece in half lengthwise making two long slim pieces. Discard on...
Now, either all at once or in stages use wood glue, clamps and a few strategically placed (pre-drilled!) screws to assemble the bottom, sides, middle ...
Now cut one 3" diameter piece of PVC and one 1" diameter piece of PVC (depending on what you started with and routed out for) to length measuring from...
Now either rip a little bit more fence material so you have an approx 1" wide piece of wood the length of your assembled unit, or as in my case pick u...
After I was done with the rest of the assembly I realized the only tape I had at the moment that had a small diameter opening that fit the small side ...
The final product.
Duct Tape Dispenser From A Tin Can!by Creativeman
Make a Wire Dispenser From a Recycled Bottleby fjordcarver
XO Tape dispenserby wanyulin0917
Duct Tape Dispenser-Ver. 2.0by Creativeman
Wooden Tape Dispenserby Don Casimiro
How to make page markers with lable, and a reusible dispenserby elkalpin
How to Make an Easy to use Tape Dispenserby Creativeman
DIY Component Organizer- Re-purposing Ti`s Samples Box as a Storage Boxby indiantinker
EASY headphone storage hacksby PropPrintables
"Sweet" Ribbon Dispenserby gwenstella
Download our new apps for iOS, Android and Windows 8!
© Copyright 2014 Autodesk Inc. All rights reserved.
PDF DownloadsAs a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.