Step 2: Drill holes on the Case

Drill holes for the LEDs and wires.
Nice and simple project. Thanks for sharing! I think you can build 4 touch switches around one 4001 CMOS chip.The circuitry will probably draw less current and the battery will live longer.
To get those values, you can add resistors in parallel or series but their values do not need to be precise. That's what I did. Here's a calculator for parallel resistors. http://www.1728.org/resistrs.htm
Thank you. I'll try to use your shematic idea in my micro LED flashlight on a super capacitor. These MOSFETs (2N7000) are dirty cheap here. As touch pads I'm going to use snap buttons. Those nickel-covered ones are easily soldered.
Thanks for the reply.The only problem is that 4001 gates can produce just a few mA, so the LEDs won't be half so bright as in your project. It can be cured by adding NPN transistors but the game is not worth candles, assuming cost and complexity. I was wondering where you managed to get those resistors of 20,40,60 and 80 Ohm. Here in Ukraine they are considered non-standard. The closest standard ones are 18,36,62 and 82 Ohm.
You mean less current with the LEDs off? From the data sheets, both have similar standby current but the chip may be great for smaller PCB's. Thanks for the suggestion.
It looks amazing :)
Love the last step - the colors look great!
Good job, this looks really cool! I want to try this sometime...

About This Instructable


37 favorites


Bio: I'm a high functioning autistic who graduated in Electronics Technician Common Core and Food Technology at BCIT. I enjoying learning new stuff and working ... More »
More by hanlin_y: DIY Self-Leveling Bike Light Mount High Powered Yellow Bike Light (Front+Side Combo) Mounting Bike Lights on Bike Baskets
Add instructable to: