Print PDF
Favorite
Email
Step 5Finishing the Box
The enclosure (minus the front panel) is a simple 4-sided box (I left the back open) of the same 1/4" hardboard glued together using wood glue.
Just like for the front panel, glossy stock prints of wood are glued to the sides of the box.
Four small rubber feet are stuck to the bottom.
Two pieces of hardboard are glued to the inside of the box to give a more snug fit for the power supply.
Just like for the front panel, glossy stock prints of wood are glued to the sides of the box.
Four small rubber feet are stuck to the bottom.
Two pieces of hardboard are glued to the inside of the box to give a more snug fit for the power supply.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Jan 16, 2009. 12:14 PMHycro
says:
Well, I'd leave the back cover off for improved ventilation.
Reply
Jul 12, 2007. 9:07 PMhondagofast
says:
This is cool, but be a little less lazy and make a back cover for the thing!
Reply
 |
Add Comment
|
