With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
This instructable walks you through the steps of creating and installing a unit that will play any audio for up to 20 seconds when a toilet is flushed. ...
Remove the "Play" button from the center of the circuit board by unbending the little metal ring that holds it in place and removing the rubber button. Cut ...
(Ignore this step if your additional push button is flat like the record button.) Cut off the "record" button. Make sure to leave enough wire on the circuit ...
Solder the flat button to the "play" 3ft long wires. (Use the button you just cut off in the previous step or use your additional button if you ...
(If your additional button is flat and you did not cut off the record button you can skip this step) Solder your additional button to the "record" button ...
Trace your speaker on the outside of the project box. Cut out a hole along your mark using an Exacto knife. Glue the speaker into the hole in ...
Cover the metal parts of the "play" button with hot glue. The button will be inside the water tank so you want all the metal to be protected. ...
Attach the 9 volt battery and place it inside the unit. Put duct tape on the back of the project box and stick it on the side or ...
How To Use A Japanese Toilet Seatby Scrabbled
make a toilet paper boat not for sailingby ilya128
Hack a Greeting Cardby designsquad
April Fools Toilet Prankby The magical duct tape kid
toilet prankby vanaka
Join 2 million + to receive instant inspiration in your inbox.
Download our apps!
© 2015 Autodesk, Inc.
Enter the email associated with your account and we will send you your username and a temporary password.
Not a member? Sign Up »
Already a member? Login »
That's a pro feature!
Want to go pro?
First step is to sign up.
By clicking "Sign me up!" you are indicating that you have read and agree to the Terms of service.
Already a member?" Login »