With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
I needed to rip up a lot of timber for some roofing joists in my workshop. They were to be filleted into some plastic boards, so I needed to do them a...
Before I start My 'able. A word on safety. I always use the relevant safety gear. Even then I have still managed to end up in the ER. Saws and electri...
The laminates are 1380mm long and a fraction under 190mm wide. I cut the first two at 1000mm for the table top. The offcuts would form the crossbracin...
I found the centre of the plank (500mm) and then offered up the saw. I lined up the centre bolt with the centre mark and then marked out the extents o...
Now that the slot is finished I ran a bead of glue down the groove of the laminate. I don't want it coming apart. The offcuts return to the fray. They...
Now onto the final layer for the table top. This is the bottom but you get my drift. This piece will run in the same direction as the top and has the ...
I had a pallet knocking around and although the temptation to set fire to it was great, I took the 3x3 and 3x1 1/2 sections to form a frame. The slat...
The final stage is to secure the saw in place. I decided not to screw through the face of the top lamination as it is on 6mm thick and the countersink...
With the saw firmly in place. The switch needs to be held in the "on" position with an exhaust clamp. All switching on and off is done form the No Vol...
Remove these ads by
Signing Up
Not NiceInappropriateSpam9,475 views
37 favorites
Posted:
Feb 21, 2012
License:
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »