Instructables

NES controller coffee table

Featured

Step 13: Rails

Picture of Rails
I planed/thicknessed the oak for the rails, then cut to length, then cut tenons.

For the rail on the front I marked out where I wanted the draws and drilled all the way through with a forstner bit.

I then cut between the holes with a jigsaw to take out the bulk.

The edges were formed by tracing along a straight edge with a flush bit in the ol' router...then I spent too damn long sanding off the burn marks that left me!
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!