Yes, I wet shave
Yes, I need somewhere to store my gear
Yes, I love the laser cut shaving stands

No, I don't have a laser cutter

Does that mean I can't have a nice stand?

NOPE, I do have a BANDSAW however

Step 1: DESIGN:

Sketch roughly what you want, might be something you've seen on here or the net or your own idea

Draw it out on paper, measure the width of your brush and razor handle for the spaces in the holder.

Try to be neat as this is going to be your first template.

Step 2: BANDSAW:

I used my bandsaw, but I could have used a fretsaw or hand saw to cut the bits out.

I shouldn't have to say be careful if you own one, but be careful just the same.

Take your time and go slow, there's no rush.

Once you've cut the pieces out, just go over the edges with a bit of fine sandpaper to neaten them off.

Step 3: CHECK:

Dry fit the pieces together to ensure all is well.

Ensure gaps are wide enough for what you want to hold.

Step 4: ASSEMBLY:

I used Superglue for plastics and put just a dab on the bits before joining them together, hold them for a few seconds to bond them.

Less glue is best, you don't want it oozing out everywhere on your finished piece.