Print PDF
Favorite
Email
Step 3Cutting the first joints
Really important!!!! make 90 degree cuts as precise as you can, If you do not do this at the end you will not have a strudy bed.
This step is really easy to understand just by looking at the pictures so please go ahead and look at the sequence of pictures below.... you simply cannot miss.
Just remember two things:
VERY STRAIGHT CUTS
And,
to have a TIGHT FIT you must cut just a little bit smaller than the width of the board (about 1/32" less than the width of the board)
When you put togeher the boards you will need to tap slightly with a hammer to make a good fit.
This step is really easy to understand just by looking at the pictures so please go ahead and look at the sequence of pictures below.... you simply cannot miss.
Just remember two things:
VERY STRAIGHT CUTS
And,
to have a TIGHT FIT you must cut just a little bit smaller than the width of the board (about 1/32" less than the width of the board)
When you put togeher the boards you will need to tap slightly with a hammer to make a good fit.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
